Difference between revisions of "AY Honors/Model Boats/Requirements"
From Pathfinder Wiki
< AY Honors | Model BoatsAY Honors/Model Boats/Requirements
m |
(Marked this version for translation) |
||
| Line 4: | Line 4: | ||
<section begin=challenge /> | <section begin=challenge /> | ||
| − | <b>1. <section begin=req1 /><noinclude><translate></noinclude>Do two of the following: | + | <b>1. <section begin=req1 /><noinclude><translate><!--T:1--> |
| + | </noinclude>Do two of the following: | ||
<noinclude></translate></noinclude><section end=req1 /></b> | <noinclude></translate></noinclude><section end=req1 /></b> | ||
| − | :<b>a. <section begin=req1a /><noinclude><translate></noinclude>Purchase and build one kit for a sailboat 10 to 15 inches (25.4 to 38.1 cm) long and about four to five inches wide and operate boat on the water for at least two minutes. | + | :<b>a. <section begin=req1a /><noinclude><translate><!--T:2--> |
| + | </noinclude>Purchase and build one kit for a sailboat 10 to 15 inches (25.4 to 38.1 cm) long and about four to five inches wide and operate boat on the water for at least two minutes. | ||
<noinclude></translate></noinclude><section end=req1a /></b> | <noinclude></translate></noinclude><section end=req1a /></b> | ||
| − | :<b>b. <section begin=req1b /><noinclude><translate></noinclude>Build a model boat with an electric motor from your own plans or from a kit, size 10 to 18 inches, (25.4 to 45.7 cm) and operate the boat for three to five minutes. | + | :<b>b. <section begin=req1b /><noinclude><translate><!--T:3--> |
| + | </noinclude>Build a model boat with an electric motor from your own plans or from a kit, size 10 to 18 inches, (25.4 to 45.7 cm) and operate the boat for three to five minutes. | ||
<noinclude></translate></noinclude><section end=req1b /></b> | <noinclude></translate></noinclude><section end=req1b /></b> | ||
| − | :<b>c. <section begin=req1c /><noinclude><translate></noinclude>Build a model boat 18 to 30 inches (45.7 to 76.2 cm) long from your own plans or from a kit. Install a small bore internal combustion engine .029 or .049 and operate for at least two successful runs of three to five minutes each. Record in writing the operating characteristics of the model and state what you did to improve its performance. | + | :<b>c. <section begin=req1c /><noinclude><translate><!--T:4--> |
| + | </noinclude>Build a model boat 18 to 30 inches (45.7 to 76.2 cm) long from your own plans or from a kit. Install a small bore internal combustion engine .029 or .049 and operate for at least two successful runs of three to five minutes each. Record in writing the operating characteristics of the model and state what you did to improve its performance. | ||
<noinclude></translate></noinclude><section end=req1c /></b> | <noinclude></translate></noinclude><section end=req1c /></b> | ||
<section end=challenge /> | <section end=challenge /> | ||
| − | <b>2. <section begin=req2 /><noinclude><translate></noinclude>Identify and define these words: | + | <b>2. <section begin=req2 /><noinclude><translate><!--T:5--> |
| + | </noinclude>Identify and define these words: | ||
<noinclude></translate></noinclude><section end=req2 /></b> | <noinclude></translate></noinclude><section end=req2 /></b> | ||
| − | :<b>a. <section begin=req2a /><noinclude><translate></noinclude>Displacement | + | :<b>a. <section begin=req2a /><noinclude><translate><!--T:6--> |
| + | </noinclude>Displacement | ||
<noinclude></translate></noinclude><section end=req2a /></b> | <noinclude></translate></noinclude><section end=req2a /></b> | ||
| − | :<b>b. <section begin=req2b /><noinclude><translate></noinclude>Center of gravity | + | :<b>b. <section begin=req2b /><noinclude><translate><!--T:7--> |
| + | </noinclude>Center of gravity | ||
<noinclude></translate></noinclude><section end=req2b /></b> | <noinclude></translate></noinclude><section end=req2b /></b> | ||
| − | :<b>c. <section begin=req2c /><noinclude><translate></noinclude>Propeller pitch | + | :<b>c. <section begin=req2c /><noinclude><translate><!--T:8--> |
| + | </noinclude>Propeller pitch | ||
<noinclude></translate></noinclude><section end=req2c /></b> | <noinclude></translate></noinclude><section end=req2c /></b> | ||
| − | :<b>d. <section begin=req2d /><noinclude><translate></noinclude>Thrust and lift | + | :<b>d. <section begin=req2d /><noinclude><translate><!--T:9--> |
| + | </noinclude>Thrust and lift | ||
<noinclude></translate></noinclude><section end=req2d /></b> | <noinclude></translate></noinclude><section end=req2d /></b> | ||
| − | :<b>e. <section begin=req2e /><noinclude><translate></noinclude>Mono hull | + | :<b>e. <section begin=req2e /><noinclude><translate><!--T:10--> |
| + | </noinclude>Mono hull | ||
<noinclude></translate></noinclude><section end=req2e /></b> | <noinclude></translate></noinclude><section end=req2e /></b> | ||
| − | :<b>f. <section begin=req2f /><noinclude><translate></noinclude>Hydro | + | :<b>f. <section begin=req2f /><noinclude><translate><!--T:11--> |
| + | </noinclude>Hydro | ||
<noinclude></translate></noinclude><section end=req2f /></b> | <noinclude></translate></noinclude><section end=req2f /></b> | ||
| − | :<b>g. <section begin=req2g /><noinclude><translate></noinclude>Bow | + | :<b>g. <section begin=req2g /><noinclude><translate><!--T:12--> |
| + | </noinclude>Bow | ||
<noinclude></translate></noinclude><section end=req2g /></b> | <noinclude></translate></noinclude><section end=req2g /></b> | ||
| − | :<b>h. <section begin=req2h /><noinclude><translate></noinclude>Keel | + | :<b>h. <section begin=req2h /><noinclude><translate><!--T:13--> |
| + | </noinclude>Keel | ||
<noinclude></translate></noinclude><section end=req2h /></b> | <noinclude></translate></noinclude><section end=req2h /></b> | ||
| − | :<b>i. <section begin=req2i /><noinclude><translate></noinclude>Transom | + | :<b>i. <section begin=req2i /><noinclude><translate><!--T:14--> |
| + | </noinclude>Transom | ||
<noinclude></translate></noinclude><section end=req2i /></b> | <noinclude></translate></noinclude><section end=req2i /></b> | ||
| − | :<b>j. <section begin=req2j /><noinclude><translate></noinclude>Cavitation | + | :<b>j. <section begin=req2j /><noinclude><translate><!--T:15--> |
| + | </noinclude>Cavitation | ||
<noinclude></translate></noinclude><section end=req2j /></b> | <noinclude></translate></noinclude><section end=req2j /></b> | ||
| − | :<b>k. <section begin=req2k /><noinclude><translate></noinclude>Heeling | + | :<b>k. <section begin=req2k /><noinclude><translate><!--T:16--> |
| + | </noinclude>Heeling | ||
<noinclude></translate></noinclude><section end=req2k /></b> | <noinclude></translate></noinclude><section end=req2k /></b> | ||
| − | :<b>l. <section begin=req2l /><noinclude><translate></noinclude>Planing | + | :<b>l. <section begin=req2l /><noinclude><translate><!--T:17--> |
| + | </noinclude>Planing | ||
<noinclude></translate></noinclude><section end=req2l /></b> | <noinclude></translate></noinclude><section end=req2l /></b> | ||
| − | :<b>m. <section begin=req2m /><noinclude><translate></noinclude>Drag | + | :<b>m. <section begin=req2m /><noinclude><translate><!--T:18--> |
| + | </noinclude>Drag | ||
<noinclude></translate></noinclude><section end=req2m /></b> | <noinclude></translate></noinclude><section end=req2m /></b> | ||
<section end=Body /> | <section end=Body /> | ||
<noinclude><translate> | <noinclude><translate> | ||
| + | <!--T:19--> | ||
[[Category:Honor Requirements|{{#titleparts:{{PAGENAME}}|1|2}}]] | [[Category:Honor Requirements|{{#titleparts:{{PAGENAME}}|1|2}}]] | ||
[[Category:Honor Requirements Revision 3|{{#titleparts:{{PAGENAME}}|1|2}}]] | [[Category:Honor Requirements Revision 3|{{#titleparts:{{PAGENAME}}|1|2}}]] | ||
<noinclude></translate></noinclude> | <noinclude></translate></noinclude> | ||
Revision as of 14:45, 28 April 2021
Model Boats
Skill Level
2
Year
1991
Version
25.11.2024
Approval authority
General Conference
1. Do two of the following:
- a. Purchase and build one kit for a sailboat 10 to 15 inches (25.4 to 38.1 cm) long and about four to five inches wide and operate boat on the water for at least two minutes.
- b. Build a model boat with an electric motor from your own plans or from a kit, size 10 to 18 inches, (25.4 to 45.7 cm) and operate the boat for three to five minutes.
- c. Build a model boat 18 to 30 inches (45.7 to 76.2 cm) long from your own plans or from a kit. Install a small bore internal combustion engine .029 or .049 and operate for at least two successful runs of three to five minutes each. Record in writing the operating characteristics of the model and state what you did to improve its performance.
2. Identify and define these words:
- a. Displacement
- b. Center of gravity
- c. Propeller pitch
- d. Thrust and lift
- e. Mono hull
- f. Hydro
- g. Bow
- h. Keel
- i. Transom
- j. Cavitation
- k. Heeling
- l. Planing
- m. Drag
