Difference between revisions of "Translations:AY Honors/Lashing/Continuous/5/es"

From Pathfinder Wiki
(Created page with "* Comience con una cuerda/soga que sea 4 o 5 veces más larga que la longitud de su proyecto. * Encuentre el centro de la cuerda y amárrela a uno de los palos de soporte. * C...")
 
m (FuzzyBot moved page Translations:Adventist Youth Honors Answer Book/Lashing/Continuous/5/es to Translations:AY Honors/Lashing/Continuous/5/es without leaving a redirect: Part of translatable page "Adventist Youth Honors Answer Book/Lashing/Continuous")
 
(One intermediate revision by one other user not shown)
Line 7: Line 7:
 
* Repita para el resto de los palos de superficie.
 
* Repita para el resto de los palos de superficie.
 
* Finalice con un nudo llano cuando todos los palos de la superficie se adjuntan.
 
* Finalice con un nudo llano cuando todos los palos de la superficie se adjuntan.
 +
<noinclude>

Latest revision as of 12:14, 8 September 2021

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (AY Honors/Lashing/Continuous)
* Start with a string/rope that is 4 or 5 times longer than the length of your project. 
* Find the middle/center of the string and attach it to one of the support poles.
* Put one of the surface sticks on top of the support pole and bring both ends of the string over this surface stick.
* Continue back down below the support pole.
* Cross the string under the support pole.
* Bring it back up and over the next surface stick and then back down and cross under the support pole.
* Repeat for the remaining surface sticks.
* End off with a square knot when all the surface sticks are attached.
<noinclude>
  • Comience con una cuerda/soga que sea 4 o 5 veces más larga que la longitud de su proyecto.
  • Encuentre el centro de la cuerda y amárrela a uno de los palos de soporte.
  • Coloque uno de los palos de superficie en la parte superior del palo de soporte y lleve ambos extremos de la cuerda sobre este palo de superficie.
  • Continúe por debajo del palo de soporte.
  • Cruce la cuerda debajo del palo de soporte.
  • Tráigalo de nuevo y por encima el siguiente palo de superficie y luego de nuevo hacia abajo y cruce por debajo del palo de soporte.
  • Repita para el resto de los palos de superficie.
  • Finalice con un nudo llano cuando todos los palos de la superficie se adjuntan.