Difference between revisions of "AY Honors/Knot/Man harness"

From Pathfinder Wiki
(Marked this version for translation)
Line 5: Line 5:
 
| image = ArtilleryLoop FinalKnot.jpg
 
| image = ArtilleryLoop FinalKnot.jpg
 
| image2 = ArtilleryLoop_HowTo.jpg
 
| image2 = ArtilleryLoop_HowTo.jpg
| use = The '''Man harness''' is a knot with a loop on the bight for non-critical purposes. This knot is used when multiple people are to pull a load. Typically one end of the rope is tied to a load, and one man harness knot per puller will be tied along its length. Each loop is then pulled by a different person.
+
| use = The '''Man harness''' is a knot with a loop on the bight for non-critical purposes. This knot is used when multiple people are to pull a load. Typically one end of the rope is tied to a load, and one man harness knot per puller will be tied along its length. Each loop is then pulled by a different person.
 
| warnings = The Man harness knot must have the loop loaded or it will slip and contract easily.
 
| warnings = The Man harness knot must have the loop loaded or it will slip and contract easily.
 
| tying_instructions =
 
| tying_instructions =

Revision as of 13:52, 8 September 2021

Man harness knot
ArtilleryLoop FinalKnot.jpg
ArtilleryLoop HowTo.jpg

Use: The Man harness is a knot with a loop on the bight for non-critical purposes. This knot is used when multiple people are to pull a load. Typically one end of the rope is tied to a load, and one man harness knot per puller will be tied along its length. Each loop is then pulled by a different person.

How to tie:

  1. Lay the rope flat
  2. Make a loop in the rope with the running end going beneath the standing part.
  3. Pull the running end down so that it crosses over the loop.
  4. Pull the bottom of the loop through the gap between the top of the loop and the running end.

WARNING: The Man harness knot must have the loop loaded or it will slip and contract easily.