AY Honors/Kites/Answer Key/es

Cometas
Asociación General Actividades recreacionales	Destreza: 1 Año de introducción: 1986

Requisitos

1

¿Cuándo fueron hechas las cometas por primera vez? ¿Cuándo fueron voladas por primera vez? Nombrar al menos tres formas en que las cometas han contribuido en la investigación científica y decir cómo cada uno ha afectado al mundo en que vivimos. Contar la historia del norteamericano Benjamín Franklin y su cometa.

2

Mencionar algunas de las formas que las cometas podrían ser utilizadas en la actualidad.

Kites are used today for the following:

1. Predicting weather (carrying aloft meteorological instruments).
2. Carrying loads of water ?
3. Spaceflight (during the recovery of space vehicles)
4. Pulling ships at sea
5. Recreation (kite surfing and skateboarding)

3

Explicar brevemente cómo volar cometas.

4

Definir los siguientes términos:

4a

Columna

4b

Varilla longitudinal

4c

Conducto de ventilación

4d

Amarre (hilo)

4e

Cubierta

4f

Marco/armazón

4g

Cola

4h

Quilla

4i

Cuerda para volar

4j

Brida

4k

Carrete

4l

5

¿Cuál es una causa común del fracaso de una cometa?

• Lack of wind.
• Too strong a wind.
• Trees or other obstacles causing turbulence.
• Essential parts of the kite or line breaking (e.g., too powerful a wind can break spars or the kite string).

6

¿Qué se debe hacer cuando una cometa hace círculos durante el vuelo?

The usual causes of a kite looping are:

1. Not enough di-hedral.
2. Poorly bridled.
3. Poorly balanced.
4. Too much wind.

If the kite starts to misbehave when already aloft the problem is most likely to be too much wind. Release tension on the line and try to pull the kite diagonally out of the wind-window and closer to you. The closer you have it, the more control of it you will have too. Most importantly you must keep the kite under your control.

7

¿Por qué algunas cometas necesitan una cola?

A kite's tail is used to add stability to the kite and keep it facing into the wind. If there is enough di-hedral this will then prevent the kite from looping. The length of a tail should be from six to nine times the length of the kite body. Some put them on the kite so that when in the air it will wave along the wind - for decoration.

8

Conocer al menos tres normas de seguridad para volar cometas.

1. Never fly a kite when it's raining and lightning - lightning can kill or cause serious burns.
2. Do not fly a kite near roads, or cars - distracting a car driver is dangerous, you could cause an accident.
3. Do not fly near power lines - you could be killed by an electric shock.
4. Do not fly near people or animals - the spine is an arrow traveling at up to 90 MPH.
5. Keep away from buildings and trees - trees eat kites!
6. Do not fly within 3 kilometres (two miles) of an active airport or aerodrome. See your local aviation authority for details.

9

Hacer lo siguiente:

9a

Enrollar correctamente la cuerda de una vara

Winding a kite line onto a straight stick without getting a large number of twists and knots onto the line is not easy, and care must be taken. First of all get a piece of straight stick about 15-20 cm long. Tightly fasten the end of your kite line securely to the center of the stick using two half hitches so that the line can not slide round the stick; then wind several turns tightly onto the center over your knot. Now wind the remainder of your kite line onto the stick using a figure of eight motion; looping your line over each end in turn, and letting it lie neatly close to the center turns; whilst doing this gradually rotate the stick so that the line does not bunch up in one place. The figure of eight motion is imperative as it puts a reverse twist on at each turn. If you do this carefully; all that you have to do to let line out is to hold the center of the stick/ball of line and let the line off each end of the stick in turn. A word of caution – hold fast to the 'winder'. If the tug of the kite pulls it out of your hand, you may find yourself running down-wind chasing a bouncing stick.

My own personal preference for a single line is to use a 'reel' but again the line must be put onto the reel by rotating the reel and not by holding the reel still; whilst looping the line over the periphery. The latter action puts a twist into the line with each turn, and with cheap line can undo the manufacturer's spinning.

Here are a couple of external links, Which give some help in winding dual lines onto commercial winders.

• http://www.expertvillage.com/video/3991_winding-kite-string.htm
• http://www.ehow.com/video_4412142_how-wind-kite-string.html

9b

Atar una línea/cuerda rota con el nudo del pescado

Adventist Youth Honors Answer Book/Knot/Fisherman's bend Note:- This is a quick and easy knot with which to fasten two ends of line. Unfortunately the weakest part is now the knot which is approximately 45 percent of the line strength. A better knot which gives a finished strength of approximately 60 percent of the line strength is the 'riggers bend' or 'hunters bend' [1]

10

Hacer volar con éxito dos de los siguientes cometas:

Here are several links to making different types of kites. Go have fun!

10a

Cometa trineo flexible

The sled kite was invented and patented by the American, William Allison in the 1950s. This kite helped pave the way for a class of kites known as "semi-rigid."

• http://hilaroad.com/camp/projects/Kite/kite.html

10b

Cometa plana

Note: There is no such thing a "stable, flying, flat kite." The nearest thing to this is probably the "Indian fighter kite" as it is flat until on the wind. It is a single line kite and is allowed to rotate and float down wind, until it is pointing in the desired direction. At this time the line is pulled tight and the bridle pulls the spine forward into the wind and the kite then assumes its dihedral, stops rotating and leaps forward under the pilot's control. The profile of this kite is almost square while the two-stick frame lies on a flat plane, with the flexible cross spar (complete with both ends tapered) is bent backwards towards the tail end. Traditionally, the covering of this kite is tissue paper but more recently for the western market is made with mylar or similar thin plastic.

Another kite which qualifies for the term "flat" is the Delta kite, made with, or without a spine. It depends for its stability on the pull of the line on its bridle shaped keel to deform the sail and give it its dihedral. We do not know when it was invented, but it is a possible contender for Benjamin Franklin's flat kite. Its one fault is that it has a tendency to fly directly over the head of the pilot, and beyond. This fault is cured by the addition of a tail or a drogue.

10c

Cometa estilo diamante con dos cañas

Diamond kites (see Eddy kites, but distinguish). Diamonds types appear from mini to very large, from low-cost beginner utility to high quality state-of-the art large target control diamonds.

The classic Diamond is also a flat kite until on the wind, but here the dihedral is forced onto the cross spar by the air flow. The cross spar lies at ninety degrees to the spine, and is spaced between one fifth and a quarter of the distance from the nose. The addition of a tail (of from six to nine times the body length) compels the kite to face into the wind.

• http://www.skratch-pad.com/kites/make.html
• http://www.diynetwork.com/diy/hobbies/article/0,2033,DIY_13951_2273218,00.html

10d

Cometa ala delta

See the earlier note under "Flat kites" as the Delta wing is flat until on the wind. As with most kites, the more accurately one half of the flying surface reflects the other, the easier it is to get it to fly true. The Delta is named after the Greek letter which it resembles in shape, if constructed without a spine. If a spine is added the profile can be altered to achieve the shape designer wishes.

By adding yet another spine and another keel, plus a strip of material between the kite is now called Delta Conyne.

• External Site to make Delta Conyne Wing Kite - http://www.kitemonger.com/kiteplan/sbd/index.html

10e

Cometa malaya

The Malay kite is a model of tailless kite. First introduced to the West in a New York newspaper article from October 1894, the Malay kite was used for recreation for centuries before this in parts of the Far East. The article detailed how a university professor ("Clayton") had erected a series of kites and bound them all together to one kite. These kites had no tail, were bowed and diamond shaped, and were referred to by the article writer as "Malay kites". However, the existence of a Malay-like design may have already been heard of in the United States sometime before the publishing of the article; in the last edition of the American Boy's Handy Book, another tailless kite is described (there referred to as a "Holland" kite). The description of this kite, which was to be included as a chapter in the book, was sent in to the author sometime around 1882, eleven years before the Malay kite was mentioned in the newspaper. Note:- to make the 'Malay' or 'Eddy' kite fly "tail less" dihedral is applied to the kite by fitting a bowline to the cross spar in like manner to that used on the Eddo, Korean, and Rocacoo. The pre-application of bow onto the cross spar is the main difference between the classic diamond and the Eddy. The other difference is that the bow enables the Eddy to fly without a tail. which the classic 'Diamond' requires.

• 
• 

10f

Cometa celular (cuadrada)

A box kite is a high-performance kite, noted for developing relatively high lift. The typical design has four parallel struts. The box is made rigid with diagonal crossed struts. There are two sails, or ribbons, whose width is about a quarter to one third of the length of the box. The ribbons wrap around the ends of the box, leaving the ends and middle of the kite open. In flight, one strut is the bottom, and the bridle is tied between the top and bottom of this strut. The dihedrals of the sails help stability. Note:- The central gap between the sails is essential, as the air flow passing around both the inside and outside of the rear 'ribbon' has a stabalising effect and seems to give the kite more 'lift' or elevation.

• 

  A Box Kite

• 

  Box Kite

• This one's a bit involved - http://www.howtomakeandflykites.com/kites-to-make/the-box-kite.html

10g

Cometa tetraédrica

A tetrahedral kite is a multi-celled rigid box kite composed of tetrahedrally shaped cells. The cells are usually arranged in such a way that the entire kite is also a regular tetrahedron. The kite can be described as a compound dihedral kite as well.

This kite was created by Alexander Graham Bell. It came about from his experiments with Hargrave's Box Kites and his attempts to build a kite that was big enough to carry both a man and a motor. Bell wrote about his discovery of this concept in the National Geographic June 1903 issue; the article was titled "Tetrahedral Principle in Kite Structure".

This style kite, while not an easy kite to make compared to the simple cross kite, is a very stable kite and is easy to fly. It flies well in moderate to heavy winds if it is properly set up.

• 

  Tetahedron

• http://www.instructables.com/id/Tetrahedral-Kite/
• http://www.cit.gu.edu.au/~anthony/kites/tetra/straw_plan/