Difference between revisions of "AY Honors/Braiding/Answer Key"

Revision as of 22:26, 8 November 2014

1. Make a three-strand braid, using hair, rope, or cord.

Step-by-step sequence for making a three-strand braid

To make a three strand braid we start with the picture on the upper left, and proceed clockwise.

Move the blue strand from the right to the center, bringing us to the second picture.
Move the black strand from the left to the center, bringing us to the third picture.
Move the red strand from the right to the center, bringing us to the fourth picture.
Move the blue strand from the left to the center, bringing us to the fifth picture.
Move the black strand from the right to the center, bringing us to the sixth picture.
Move the red strand from the left to the center, bringing us to the seventh picture which has the strands in the same order as the first.

The sequence of left-to-center, right-to-center, left-to-center, right-to-center repeats until the braider reaches the end of the strands or decides to quit.

2. Make a zipper pull or a key chain using the four-strand round or square braid.

How to get started on a four-strand round or square braid.

This is an easy project that does not take very much time. To start, you will need: a keyring or other ring/fastener, and two strands of gimp (flat, plastic string), each strand about 3-4 feet long.

Fold each strand in half and thread through the ring/fastener. Then begin braiding.

Step 1: Cross over two strands that are opposite each other (see illustration).
Step 2: Thread the cross-strands through: "over 1, under one".
Step 3: Pull tight

Repeat until the zipper pull or key chain reaches the desired length (4-5 inches).

3. Make a four-strand hanger cover.

How to braid using four strands.

How to do a four-strand braid around a hanger.

First, you must learn to do the four strand braid (not the round or square braid). The way to remember this is "under 2, over 1." Follow the illustration.

To make a hanger cover, just do this braid around the hanger.

4. Make a four-strand round braid lanyard.

How to make an adjustable lanyard with a four-strand braid.

Follow the instructions for a four-strand braid from requirement 3 above, starting with two 8-9 foot strands folded in half. At the end, start doing a square braid around the first part, forming a loop. This can be adjusted when you are done.

5. Know how to start and end all projects.

Adventist Youth Honors Answer Book/Braiding/Start

References

@@ Line 51: / Line 51: @@
 ==5. Know how to start and end all projects. ==
-How to start or end depends on the material being braided.
+{{:Adventist Youth Honors Answer Book/Braiding/Start}}
-===Starting===
-;Rope, string, or lace: Lay the ropes (or strings or laces) parallel to one another with the ends even and tie an overhand knot in the entire bundle.
-{{:Adventist Youth Honors Answer Book/Knot/Overhand}}
-;Hair: Bind the hair you wish to braid using an elastic band near the head.  Divide into the desired number of equal-diameter strands.
-;Leather: A wide leather strap can be cut into strips, but left intact near one end.
-===Ending===
-;Rope, string, or lace: Tie the bundle into an overhand knot.
-;Hair: Bind the braid with a rubber band or a decorative hair elastic.
-;Leather: Glue the strands in place, rivet them to another piece, or firmly sandwich them between two other pieces of leather.
 ==References==
 [[Category:Adventist Youth Honors Answer Book/Completed Honors|{{SUBPAGENAME}}]]