All translations
From Pathfinder Wiki
Enter a message name below to show all available translations.
Found 2 translations.
| Name | Current message text |
|---|---|
| h English (en) | ===Pouring the plaster=== Pour the wet plaster into one corner of the mold and allow the plaster to flow across to the other side. When the mold is full, tap it a few times to help work out any air bubbles. If you need a hanger, place it in the plaster ''at the top'' (pay attention!). You can buy hangers or you can use a paper clip. Make sure the hanger is well embedded in the plaster. ===Releasing the mold=== Once the plaster heats up, you can remove it from the mold. Do this by gently pulling the edges of the mold away from the cast piece. Work your way around until the mold has been separated all around (it's OK to let the mold snap back into place). Do not overflex the mold or you may crease it. Turn the mold upside down over the support base (the bag of rice) and gently shake it until the piece pops out. It should land gently on the support base. Set the piece aside to allow it to finish curing. For fastest curing, set the piece on a grate so that air may circulate over all surfaces. |
| h Spanish (es) | {{clear}} |
