Translations:Adventist Youth Honors Answer Book/Arts and Crafts/Metal Craft/12/en

Once the side panels are cut out, use the long dimension of the triangle (the hypotenuse) to set the width of the top and bottom panels. The length of these pieces should be equal to the longest dimension of the grill. Once these pieces are cut out, you need to put a small X crease in them to stiffen them. This can be done by either laying them over a length of upturned angle iron and tapping the crease in with a rubber mallet, or by laying it flat on a floor, and then laying a stiff straight-edge (such as a yardstick) wherever you want the crease. Then work your way under the free end as you hold the straight-edge firmly in place.