Investiture Achievement/Friend/Outdoor Living

From Pathfinder Wiki
< Investiture Achievement‎ | FriendInvestiture Achievement/Friend/Outdoor Living/en /
Revision as of 00:55, 23 May 2021 by FuzzyBot (talk | contribs) (Updating to match new version of source page)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Other languages:


IA logo.png
Strip invest friend.jpg
Friend/Outdoor Living


Investiture Achievement/Friend/Outdoor Living/en/requirement 1 There are many more than 10 knots listed in the Knot Tying/en Honor answers, and the Friend candidate is free to tie any ten of them. Below we present ten selected knots based on how easy they are to tie as well as how useful they are.


Knot tying is an important part of Pathfindering with tie ins to Investiture Achievement and many other honors such as the various Camping Honors, Rock Climbing, Pioneering and others.

An effective way to teach knots in a club setting is to have the staff and the older Pathfinders (the ones who already have the Knot Tying Honor) each teach a single knot at a knot tying station. The Pathfinders who are learning the knots will rotate through the stations. After a set time, ring a bell to signal that it's time to rotate, and do not allow the students to rotate until the bell rings (otherwise, they will all gravitate to the same table).

Using this approach, each of the teachers need only learn a single knot well enough to teach it, and the students will have a chance to receive one-on-one instruction for every knot. Allow at least seven or eight minutes per station. You can do this over more than one meeting if necessary, and you can involve the entire club at once rather than only a single unit.

Prior to the meeting, the rope may be cut to the proper length. Some instructors consider cutting rope during a meeting a waste of valuable teaching time, while others use it as an opportunity to teach proper binding of the rope. To prevent the cut rope from unravelling, wrap a small piece of duct tape around it before you make the cut - then cut the tape in half. This will save time, as it binds both ends of the cut in one shot.

The length of each rope should be suited to the knot it will be used for. Note that a figure eight knot does not require as much rope as a timber hitch, and that it is impossible to tie a knot on a rope that it too short to hold it. Conversely, using too much rope for small knots is a waste of good rope (and money!). Remember that the amount of rope wasted on each knot will be multiplied by the number of students.

A good way to determine proper rope length is to tie the desired knot using a long piece of rope, cut it, and then untie it. That's how long it needs to be. Cut as many of that length as you will have students, put them in a plastic baggie, and label the bag. You may have the knot instructors cut their own ropes, or you may have a squad of TLT's do this. Or you could do it yourself (but that would be depriving your TLT's and/or instructors of a valuable experience).

Two knot tying stations can easily share an eight foot table and a hot-melt glue gun - assuming the students will be mounting the knots on a board as they tie them. If you are organized and have the space, you can store their knot boards from year to year and let them add to it each year. By the time they are in the Ranger class, they will appreciate not having to tie 25 knots all at once.

A good knot board can be made from a length of lumber - 24"x12"x3/4" makes a good sized board if you are using quarter-inch diameter rope. A stick can be fastened along the edge of the board to make a convenient place to tie the hitches.

For a professional-looking knot board, prepare labels for the knots using a label maker. Again, this is something that should be done prior to the meeting, as making labels and distributing them is not an effective use of instruction time. You should also make labels with each student's name (or have students label their boards neatly) so that they will be able to find their knot boards in the future and to prevent disputes over knot board ownership. You might also consider labeling the knot boards before they are given to the students (and before the knots are tied), as this makes it easy to figure out which knots the student still needs to learn.


Here's the list:

  1. Figure Eight - A stopper knot that is easy to untie.
  2. Stevedore - A bigger stopper knot that is even easier to untie.
  3. Square - Useful in first aid, and widely known by many.
  4. Surgeon's - A variation on the square knot, but can be held tighter when tying.
  5. Sheet bend - An easy knot that is the first choice for joining two ropes.
  6. Double sheet bend - A more secure version of the sheet bend.
  7. Slipped sheet bend - An easily untied version of the sheet bend.
  8. Bowline - A very hand loop, useful in rescue situations.
  9. Clove hitch - The first knot used when lashing.
  10. Taut-line hitch - Very useful for anchoring a tent.

And here are the knots: Adventist Youth Honors Answer Book/Knot/Figure 8 Adventist Youth Honors Answer Book/Knot/Stevedore's Adventist Youth Honors Answer Book/Knot/Square Adventist Youth Honors Answer Book/Knot/Surgeons Adventist Youth Honors Answer Book/Knot/Sheetbend Adventist Youth Honors Answer Book/Knot/Double sheet bend Adventist Youth Honors Answer Book/Knot/Slipped sheet bend Adventist Youth Honors Answer Book/Knot/Bowline Adventist Youth Honors Answer Book/Knot/Clove hitch Adventist Youth Honors Answer Book/Knot/Taut-line hitch

Investiture Achievement/Friend/Outdoor Living/en/requirement 2 For tips and instruction see Camping Skills I.

Trail Friend Friend Ribbon.jpeg

There are no additional requirements in this section for the Advanced Ribbon.