AY Honors/Leather Craft/Answer Key

From Pathfinder Wiki
< AY Honors‎ | Leather CraftAY Honors/Leather Craft/Answer Key /
Revision as of 06:47, 13 July 2007 by 146.171.254.65 (talk) (Removed redirect to Leather Crafting article, started detailed description of leather carving)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

This article describes leather carving in detail. For information about leather craft in detail, please see Leather Crafting

Leather carving is the process of giving a three-dimensional appearance to leather by a process of cutting and stamping the surface.


Raw Materials

The only type of leather suitable for carving is vegetable tanned, top grain leather. This is because the vegetable tanning process allows the leather to absorb water, which is used to soften the leather before the carving process, and the grain of the leather is necessary to allow the leather to hold the shape after the carving process is complete. Other leathers lack these two essential qualities.


Tools

Leather carving is accomplished using three main tools:

  • Swivel Knife
  • Rawhide Mallet
  • Stamp Set


Preparation

Before carving can commence, the leather must be prepared to accept the tooling by 'casing' it. This is done by applying water to the grain side of the leather with a sponge. After a short time, the surface of the leather will darken and feel cool to the touch. At this point, the leather is ready for carving. For some large projects, it may be necessary to re-case the leather as it dries during the carving session.


Swivel Knife Cuts

When the leather has been properly cased, the swivel knife is used to make the bold cuts that form the backbone of the carved image. These cuts are made to a depth of up to approximately half the thickness of the leather being used, depending on the effect desired by the leather worker. Care must be taken during this step to keep the swivel knife vertical at all times, as any tilt is detrimental to the ability of the leather to be properly stamped later in the carving process.


Headline text