|*Edits to the Pathfinder Wiki will be disabled on July 27, 2021 in preparation for an upgrade. The upgrade is scheduled to take place on August 10, 2021. During the upgrade, we expect the Wiki to be available only intermittently. Once the upgrade is complete, users will again be able to perform edits. Thanks!|
*Las ediciones al Wiki de Conquistadores se desactivarán el 27 de julio de 2021 en preparación para una actualización. La actualización está programada para el 10 de agosto de 2021. Durante la actualización, esperamos que el Wiki esté disponible solo de forma intermitente. Una vez que se complete la actualización, los usuarios podrán volver a realizar ediciones. ¡Gracias!
Adventist Youth Honors Answer Book/Arts and Crafts/Native Brush Construction
|Native Brush Construction|
| General Conference
|| Skill Level 3
Year of Introduction: Unknown
- 1 1. Assist in setting out the ground of a simple house squarely and accurately.
- 2 2. Assist with choosing and cutting proper timber from the bush for posts, floor, rafters, wall plates, studs, steps and doors.
- 3 3a. Plait local materials for walls.
- 4 3b. Make sections for a wall 1m x 1m and show two different wall patterns.
- 5 4. Show ability to thatch a roof correctly, especially the ridge and hips using kunai grass, sago palm leaves, coconut palm leaves or any other materials.
- 6 5. Where applicable select, prepare and use vines for tying and lashing.
- 7 6. Take part in building a house not less than 4m x 2m using native materials. In building the house practice all demonstrations nos. 1-5. Show while building the house that you have taken measures to keep it free from termites.
- 8 7. Demonstrate ability to name, use and care for the following tools: ax, saw, hammer, chisel, bush knife, ruler and tape spade.
- 9 References
This Honor is a component of the Artisan Master Award.
1. Assist in setting out the ground of a simple house squarely and accurately.
A house that is "square" is one whose corners form right angles (90°). The house itself can be any type of rectangle or collection of rectangles (it doesn't have to be a square).
To lay out a perfect rectangle, the wall that connects the corners A and B (we'll call that wall AB) must be the same length as the wall that connects corners C and D (which we'll call CD). Further, wall BC must be the same length as AD. But that's just the starting point. Even if all the walls are the proper length, the rectangle can be skewed to form a parallelogram (see illustration)
To correct for this, all we need to do is make sure the diagonals in our rectangle are equal length. The diagonals are the imaginary lines connecting A to C and B to D (that is, AC and BD).
It is best to choose the location of two corners of the house and drive stakes in the ground to mark where they will go. Then take the remaining measurements from these two corners, adjusting the position of the other two corners until the diagonals are equal and the sides are the right length. Then drive these stakes in the ground. Once the stakes have been driven, measure the lines again. If the distances are wrong, start over. If a house is laid out crooked, it will affect every other aspect of its construction, making every job in building it more difficult.
2. Assist with choosing and cutting proper timber from the bush for posts, floor, rafters, wall plates, studs, steps and doors.
3a. Plait local materials for walls.
3b. Make sections for a wall 1m x 1m and show two different wall patterns.
4. Show ability to thatch a roof correctly, especially the ridge and hips using kunai grass, sago palm leaves, coconut palm leaves or any other materials.
See the Thatching honor for detailed instruction.