Difference between revisions of "AY Honors/Forestry/Answer Key"
(skill level 2) |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | {{ | + | {{Expand|date=March 2008}} |
| − | + | [[Image:Measuring dbh.JPG|thumb|right|250px|A properly measured tree with a diameter of 16 inches (40.64 cm).]] | |
| + | A '''Diameter tape''' (D-tape)is a form of [[dendrometer]] that consists of a cloth or metal tape that is mainly used to measure [[diameter at breast height]] (DBH). DBH is measured at a fixed height of 4.5 feet (137.16 cm) above the ground, where it is most convenient to measure [[diameter]]. DBH is measured up high so to avoid measuring a trees' butt swell. Butt swell is where the base of the tree is unconventionally fatter then the rest of the tree. height and diameter are used to determine the volume of a given tree, measuring above the butt swell is required to provide the most accurate measurement.<ref> http://www.cnr.vt.edu/dendro/forsite/dtape.htmAs</ref> | ||
| + | |||
| + | Diameter is easily measured because the tape is calibrated in units of 3.14(pi) [[inch]]es or [[centimeter]]s. The tape is actually measuring the trees circumference but since circumference and diameter are related by pi, the diameter can easily be obtained.The only problem with the diameter tape is that the measurements assume the tree's trunk cross-sections are perfectly circular. Thus the diameter tape just gives an approximation, regardless it is the most commonly used dendrometer for DBH.<ref>Moran,L.A, and R.A Williams.2002. Comparison of three dendrometers in measuring diameter at breast height. ''Northern Journal of Applied Forestry'' 19:28-33.</ref> | ||
| + | |||
| + | == Measuring Diameter == | ||
| + | |||
| + | Mrs. Knicker | ||
| + | |||
| + | ==See also== | ||
| + | * [[Timber cruise]] | ||
| + | * [[Biltmore stick]] | ||
| + | |||
| + | == References == | ||
| + | |||
| + | <references/> | ||
| + | |||
| + | [[Category:Forest modelling]][[Category:Dimensional instruments]] | ||
Revision as of 17:35, 14 September 2009
A Diameter tape (D-tape)is a form of dendrometer that consists of a cloth or metal tape that is mainly used to measure diameter at breast height (DBH). DBH is measured at a fixed height of 4.5 feet (137.16 cm) above the ground, where it is most convenient to measure diameter. DBH is measured up high so to avoid measuring a trees' butt swell. Butt swell is where the base of the tree is unconventionally fatter then the rest of the tree. height and diameter are used to determine the volume of a given tree, measuring above the butt swell is required to provide the most accurate measurement.&
Diameter is easily measured because the tape is calibrated in units of 3.14(pi) inches or centimeters. The tape is actually measuring the trees circumference but since circumference and diameter are related by pi, the diameter can easily be obtained.The only problem with the diameter tape is that the measurements assume the tree's trunk cross-sections are perfectly circular. Thus the diameter tape just gives an approximation, regardless it is the most commonly used dendrometer for DBH.&
Measuring Diameter
Mrs. Knicker
See also
References
- ↑ http://www.cnr.vt.edu/dendro/forsite/dtape.htmAs
- ↑ Moran,L.A, and R.A Williams.2002. Comparison of three dendrometers in measuring diameter at breast height. Northern Journal of Applied Forestry 19:28-33.
