Difference between revisions of "AY Honors/Knot/Double sheet bend"

From Pathfinder Wiki
(Marked this version for translation)
m
 
(4 intermediate revisions by the same user not shown)
Line 1: Line 1:
<noinclude><translate><!--T:1-->
+
<noinclude><translate><!--T:2-->
 
</noinclude>
 
</noinclude>
 
{{Knot
 
{{Knot
Line 8: Line 8:
 
|tying_instructions =
 
|tying_instructions =
 
To tie the double sheet bend, start by making a bight in the larger line. Pass the working end of the smaller line up through the bight, around behind the bight, and beneath the loop in the smaller line (that's a sheet bend). Then once again, pass the working end along the same path, around behind the bight and beneath the loop in the smaller line.
 
To tie the double sheet bend, start by making a bight in the larger line. Pass the working end of the smaller line up through the bight, around behind the bight, and beneath the loop in the smaller line (that's a sheet bend). Then once again, pass the working end along the same path, around behind the bight and beneath the loop in the smaller line.
|warnings=As with the standard sheet bend, the two free ends should end up on the same side of the knot. If they do not, a ''left-handed double sheet bend'' results, which is much weaker.
+
|warnings=As with the standard sheet bend, the two free ends should end up on the same side of the knot. If they do not, a ''left-handed double sheet bend'' results, which is much weaker.
 
}}
 
}}
 
<noinclude></translate></noinclude>
 
<noinclude></translate></noinclude>
[[Category:Adventist Youth Honors Answer Book|{{SUBPAGENAME}}]]
 

Latest revision as of 04:07, 15 July 2022

Double sheet bend
Double sheet bend.jpg

Use: The double sheet bend or double becket bend is a strong knot used to tie two ropes (usually of different thicknesses or rigidity) together. It is a doubled version of the sheet bend.

How to tie:

To tie the double sheet bend, start by making a bight in the larger line. Pass the working end of the smaller line up through the bight, around behind the bight, and beneath the loop in the smaller line (that's a sheet bend). Then once again, pass the working end along the same path, around behind the bight and beneath the loop in the smaller line.

WARNING: As with the standard sheet bend, the two free ends should end up on the same side of the knot. If they do not, a left-handed double sheet bend results, which is much weaker.