Difference between revisions of "AY Honors/Camping/Pitch and strike a tent"

Revision as of 20:09, 28 December 2006

The details vary for every type of tent there is, so we provide only general tips here. First, carefully read the instructions that came with your tent. If it's a new tent, keep the instructions. You might be surprised how easy it is to forget which pole goes where.

First, unpack the tent and spread it on the ground. Some people like to put the ground cloth under the tent, and others like to put it inside. If you're going to put it beneath the tent, spread it out first. Before doing anything else, lie down on the ground cloth and test each sleeping area. If you feel a lump get rid of it now.

Then lay out the tent's envelope (that is, the cloth part that is not the fly). Find the door and orient it where you want it. Then stake it down. This will prevent the wind from blowing it away while you are trying to raise it. Slide the poles into the tubes, but do not raise the tent until the main poles (usually two of them) are all in place. Then raise them together. There are usually aluminum "hooks" shaped somewhat like a question mark and a couple of inches ling that the poles will fit over. If so, place the ends of the pole over these. Then insert any remaining poles and anchor them into place as well. Then throw the fly over the tent, being careful that the up side is up and the front side is to the front.

Flys often have elastic ropes that attach to plastic clips near the pole anchors, and they also generally have a rope at the four major corners. These should be anchored such that the fly is held off the tent's canopy, usually by staking them down or tying them to a tree. In the "olden days" a taut line hitch would be used to tighten these ropes, but these days the ropes are fitted with a three-hole plastic strap. The end of the rope passes through the bottom-most hole and is tied off with a stopper knot. From there, the rope goes to the anchor (tree, stake, etc), and passes through the middle hole, and then again through the top hole. The plastic strap can then be slid up and down the rope to adjust hte tension. Do not over-tension these ropes - they should have some give so that the tent can move a little with the wind. Of they are too tight, the wind will rip the stakes from the ground or topple the tent.

@@ Line 1: / Line 1: @@
 The details vary for every type of tent there is, so we provide only general tips here.  First, carefully read the instructions that came with your tent.  If it's a new tent, '''keep the instructions.'''  You might be surprised how easy it is to forget which pole goes where.
-First, unpack the tent and spread it on the ground.  Some people like to put the ground cloth under the tent, and others like to put it inside.  If you're going to put it beneath the tent, spread it out first.  Then lay out the tent's envelope (that is, the cloth part that is not the fly).  Find the door and orient it where you want it.  Then stake it down.  This will prevent the wind from blowing it away while you are trying to raise it.  Slide the poles into the tubes, but do not raise the tent until the main poles (usually two of them) are all in place.  Then raise them together.  There are usually aluminum "hooks" shaped somewhat like a question mark and a couple of inches ling that the poles will fit over.  If so, place the ends of the pole over these.  Then insert any remaining poles and anchor them into place as well.  Then throw the fly over the tent, being careful that the up side is up and the front side is to the front.
+First, unpack the tent and spread it on the ground.  Some people like to put the ground cloth under the tent, and others like to put it inside.  If you're going to put it beneath the tent, spread it out first.  Before doing anything else, lie down on the ground cloth and test each sleeping area.  If you feel a lump get rid of it now.
+Then lay out the tent's envelope (that is, the cloth part that is not the fly).  Find the door and orient it where you want it.  Then stake it down.  This will prevent the wind from blowing it away while you are trying to raise it.  Slide the poles into the tubes, but do not raise the tent until the main poles (usually two of them) are all in place.  Then raise them together.  There are usually aluminum "hooks" shaped somewhat like a question mark and a couple of inches ling that the poles will fit over.  If so, place the ends of the pole over these.  Then insert any remaining poles and anchor them into place as well.  Then throw the fly over the tent, being careful that the up side is up and the front side is to the front.
 Flys often have elastic ropes that attach to plastic clips near the pole anchors, and they also generally have a rope at the four major corners.  These should be anchored such that the fly is held off the tent's canopy, usually by staking them down or tying them to a tree.  In the "olden days" a taut line hitch would be used to tighten these ropes, but these days the ropes are fitted with a three-hole plastic strap.  The end of the rope passes through the bottom-most hole and is tied off with a stopper knot.  From there, the rope goes to the anchor (tree, stake, etc), and passes through the middle hole, and then again through the top hole.  The plastic strap can then be slid up and down the rope to adjust hte tension.  Do not over-tension these ropes - they should have some give so that the tent can move a little with the wind.  Of they are too tight, the wind will rip the stakes from the ground or topple the tent.