AY Honors/Communications - Advanced/Answer Key

From Pathfinder Wiki
< AY Honors‎ | Communications - AdvancedAY Honors/Communications - Advanced/Answer Key/en /
Revision as of 00:52, 23 May 2021 by FuzzyBot (talk | contribs) (Updating to match new version of source page)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Other languages:
Communications - Advanced

Skill Level

3

Year

1956

Version

31.10.2024

Approval authority

General Conference

Communications Advanced AY Honor.png
Communications - Advanced
Vocational
Skill Level
123
Approval authority
General Conference
Year of Introduction
1956
See also


1

Do one of the following:


1a

Send and receive by International Morse Code at the rate of eight words per minute using flashlight, whistle, mirror, buzzer, or key. (Five-letter words, minimum of 20 words.)

1b

Send and receive by semaphore code at the rate of 12 words per minute using semaphore flags. (Five-letter words, minimum of 20 words.)

1c

Send and receive by International Morse Code at the rate of eight words per minute using wigwag flags. (Five-letter words, minimum of 20 words.)


Adventist Youth Honors Answer Book/Wigwag Code

Note that the US Army use of Wigwag does not use Morse Code but rather a single flag moved between positions 1, 2 and 3. Each letter is represented by a series of numbers.

The oldest flag system associated with the US Army Signal Corps is called Wig-wag. The name reflects the concept of back and forth movement as a means of signaling through motion. (PLEASE NOTE: Often this system has been misidentified as “Wig-wam.” A Wig-wam is a temporary arched framework structure overlaid with bark or hides to provide shelter used by Native Americans of the Algonquian language group.) Wig-wag is the signaling system developed for military field operations by Army surgeon Albert J. Myer prior to the Civil War. He developed this system based on a two element “tap-code” he created for the deaf. Myers’ Wig-wag system uses one flag for signaling. The position of the flags, left, right, front, represent the numerals 1, 2, 3 respectively and combinations of these numerals are used to convey the message. The one-flag Wig-wag system used a cotton flag of two, four, or six feet square. The larger the flag, the greater distance it could be seen. The flag pole could be extended to a length of 16 feet using 4-foot segments joined with brass fittings. It took a strong soldier to wave a 16 foot pole with a 6-foot square flag on it for an hour or more, especially in wind, heat and probably under enemy fire. During night operations, the flag was replaced with a specially designed kerosene fueled torch, but employed exactly as the flag would be during daytime. During daytime operations, different sizes and colors of flags were employed based upon atmospheric conditions, such as clouds, haze, blue sky, etc. The signal soldier had these varieties of flags as part of their kit, but at any one time, only one flag or torch was used for signaling.

The Myer Wig-wag system and associated codes were used by both Union and Confederate armies during the Civil War. The Union Navy also employed this system and it served as the first Joint Signal Code between the Army and Navy until the end of the nineteenth century.

For the code and photos see here.




References