Difference between revisions of "AY Honors/Welding/en"
From Pathfinder Wiki
< AY HonorsAY Honors/Welding/en
(Updating to match new version of source page) |
(Updating to match new version of source page) |
||
Line 7: | Line 7: | ||
|instructor=qualified | |instructor=qualified | ||
|complete_course=true | |complete_course=true | ||
+ | |cnt_answerKey_variants=2 | ||
+ | |answerKey_1=;;1 | ||
+ | |answerKey_2=;;2 | ||
+ | |cnt_requirements_variants=2 | ||
+ | |requirements_1=GC | ||
+ | |requirements_2=NAD | ||
}} | }} | ||
Revision as of 22:48, 21 July 2021
Overview
The Challenging Part
The most challenging requirement of this honor is probably this:
11. Using the designated processes, perform the following:
- a. PAC: Make one straight cut at least three inches long in mild steel or aluminum.
- b. SMAW: Complete i and ii, or complete iii.
- i. Make two bead-on-plate welds at least two inches total length
- ii. Make one square-groove weld in the flat position
- iii. Make one corner weld in the flat position
- c. GMAW: Complete i and ii, or complete iii.
- i. Make two bead-on-plate welds at least two inches total length
- ii. Make one square-groove weld in the flat position
- iii. Make one lap weld in the flat position
Categories:
- Pages using DynamicPageList3 parser function
- Category:Has insignia image
- AY Honors/Complete a Course/en
- AY Honors/Secondary
- Category:AY Honors/HonorLanding
- AY Honor Categories/Vocational/en
- Category:AY Honors/Vocational
- AY Honors/Introduced in 1978/en
- Category:AY Honors/Skill Level 3
- Category:AY Honors/Approved by North American Division
- Uses HonorLanding Template
- AY Honor Config/Has Requirement Variants
- AY Honor Config/Has Answer Key Variants
- Missing Localization/All/Welding (NAD) AY Honor.png/en